if you have a PA with physical disks it should be nice to have a mode to monitor the raid/disk status using SSH
example with configured raid and failed disk
show system raid detail
Overall System Drives RAID status Good
--------------------------------------------------------------------------------
Drive status
Disk id Sys1 Present (Micron_5300_MTFD)
Disk id Sys2 Present (Micron_5300_MTFD)
--------------------------------------------------------------------------------
Partition status
panlogs clean
Drive id Sys1 active sync
Drive id Sys2 active sync
maint clean
Drive id Sys1 active sync
Drive id Sys2 active sync
sysroot0 clean
Drive id Sys1 active sync
Drive id Sys2 active sync
sysroot1 active
Drive id Sys1 active sync
Drive id Sys2 active sync
pancfg clean
Drive id Sys1 active sync
Drive id Sys2 active sync
panrepo clean
Drive id Sys1 active sync
Drive id Sys2 active sync
swap clean
Drive id Sys1 active sync
Drive id Sys2 active sync
Logging Drives RAID status
--------------------------------------------------------------------------------
Disk Pair Log Available
Status clean, degraded
Disk id Log1 Present
model : ST2000NX0253
size : 1907729 MB
status : active sync
Disk id Log2 Present
model : ST2000NX0253
size : 1907729 MB
status : failed
As you can see in this ecample Disk id Log2 has status failed and Disk Pair Log is Available, but degraded.
Further information you can find here: https://docs.paloaltonetworks.com/wildfire/9-0/wildfire-admin/use-the-wildfire-appliance-cli/wildfire-appliance-operational-mode-command-reference/show-system-raid.html
